Chair raiser for swivel chair

Project  / Project number: WO.66.11.19C  /  Status:

IMG_2479

Chair raiser for swivel chair

0

The challenge

Gary could not use his favourite swivel arm chair as it was too low and no raisers were avaliable.

The requirement was to raise the chair by approx 75mm

0

The solution

I made a platfrom to raise the chair base approx 75mm higher off the floor

The top and bottom are 9mm MDF and the eight spacers are 70mm x 45mm Pine

The top and bottom plates are glued and screwed to the spacers

The chair is fastened to the base with eight tie wraps through holes drilled in the base of the chair stand, this allows the chair still to swivel.

The benefit

Gary is able to sit once again in his favourite chair.

Leave a Reply

Your email address will not be published. Required fields are marked *